Hi all. I'm having this problem after the introduction of a new graphics card (ATi Radeon X800 Pro 256). I can't set hunkmeg to anything higher than 128. I get an error message which says I dont have sufficient memory, it might be because my hd is full (which it isn't). I have 1 gig of RAM. And I have 4 gig of virtual memory set on windows on the primary drive. I tried setting hunkmeg higher while running in safe mode. Same problem, same error. Also, now there is lag. It's a P4 2.8 chip. And I have 10 meg of broad band dsl connection.