hey can u guys help me when i try to start a new map it says could not initialize reming engine features and when i try again it says could not load selected mod dll (dxp2) wats wrng plz help i want to start making maps and sometimes when i kill a unite instead of the blood going on the ground it just makes a wall of blood ????? can somewon help:confused:
Ok this happened to me...I couldn't fixed it and found out that my graphics card wasn't good enough to use the ME but than put it on the laptop and it works...But I don't know how to fix it other than that for me it was because my graphics card sucked! hope that helps a little
yea i want to a new card and stuff but wat about the map editor problem i want to make maps :(
Where do you have the map editor? It should be in your Dark Crusade directory. Then you save and load maps to/from your mp folder, which is located in your DXP2 folder. As for the blood wall, was this always happening or is it something new? The problem is with your graphics config, not necessarily your graphics card. go into your graphics option in Dc and turn your options up if they are low. ie, model detail and what not. If this causes problems with lag or anything, just lower them a bit.
yea it is in my dc directory but when i try to load a new map it says could not initialize reming engine features and then when i try again it says could not load selected mod dll (dxp2)
Sorry, I don't know what the problem is then. How is the blood thing working out for you otherwise?
and what gf card do you actually have?
i wan get the XFX GeForce 8600 GT XXX Video Card for my gateway and i am not sure if it will fit thou am better sure it will i just wan duoble check
Vardor;4016661i wan get the XFX GeForce 8600 GT XXX Video Card for my gateway and i am not sure if it will fit thou am better sure it will i just wan duoble check
That should be more than enough.
okey i just wanted to make sure that its not to big