im getting used to this map editing now but i dont know how to make hills that you can walk on and slopes and cover areas you walk at can someone tell me how
If you use the hieghtmap editor you can make hills. It will automatically set the mipass if the slope is too steap. Use the smoothening tool to level out your slope until it shows a grey (not red) area in the impass editor. You can change this manually by just painting the slope as "passable" terrain, but then your troops may end up walking straight up a wall, which just doesn't look good. Hope all that was easy enough to understand. :)
thanks but how do i make streams i can walk in and how do i make bridges
Hmmm. The only real water available in the ME is at the very bottom of the map. If you want to make a stream, lower the ground hieght until it hits water, kind of like digging for water. You dig deep enough and you'll hit it. As far as bridges, if you want people to be able to walk across them they have to be pretty low because you basicaly have to raise the ground level of a strip of land across your stream, then place bridge side objects on either side to make it look like a bridge. Afterwards so it doesn't look like the rest of the ground, use the decal tool and place a decal of cobble or stone path or something. Most of the time, the way the ME works is you have to disguise something like something else to make it work. ;)
I see Thanks you very much :)
NP. Happy mapping. :D
Remember to always post if you have a problem.We're here to help.