Where'd that brush come from? -1 reply

Please wait...

El Cuko

I don't spend enough time here

50 XP

12th May 2002

0 Uploads

14 Posts

0 Threads

#1 15 years ago

Thanks for reading ... I'm about midway through compiling my map. There are a few brushes (Visible and obstructive) in game that do not show up in radiant, so I'm unable to do anything about them. This has happened before, but I never arrived at a solution. How can I find and destroy these brushes in the editor?




Bell

I want to be like the Admins

50 XP

1st July 2002

0 Uploads

208 Posts

0 Threads

#2 15 years ago

i've had this, takes a bit of guess work. but i used no clip to fly around and see where the brush was located as best i could. then in radiant i made a brush that i guessed completely covered the area where this rogue brush is. then i chose select inside, if the brush you made disappears then most likely the invissible brush is selected, then hit backspace key to delete it. then compile and see if you got lucky. you may end up deleting other stuff but thems the breaks; hope someone else has better method.

now if the brush goes past a wall and you can't tell if it extends into the void, then the brush you make to select should be dragged to almost the edge of your grid to make sure you get it all. thats what i had to do. a few light entities went with it but whatever.




El Cuko

I don't spend enough time here

50 XP

12th May 2002

0 Uploads

14 Posts

0 Threads

#3 15 years ago

Thanks- Good advice - can't believe I hadn't thought of that. I think it'll work. :agreed: