startrek elite force 2 -1 reply

Please wait...

Dorsflando

I'm too cool to Post

50 XP

26th June 2003

0 Uploads

1 Posts

0 Threads

#1 15 years ago

Hi! I'm in the engineering room (while my teammates are been attacked for the first time by aliens); there I have to use my tricorder on a board; you have to connect the different colors, avoiding shortcuts by the red nodes; so I did, but nothing works!! (Everything turns blue or yellow but without result) Thanks a lot for helping!




NCC_007

Games Rookie

50 XP

22nd June 2003

0 Uploads

85 Posts

0 Threads

#2 15 years ago

Which engineering are you in, Enterprise or Dallas? if its enterprise then u hav a set amount of time to sort out the console before the warp core goes beyond safty limit which ends up in ejecting the core then barclay tells the you the core to eject the core and the panel to type it in is located near to where barclay is at one of the engineering stations.




Sollejon

Lt. J.G.

50 XP

28th June 2003

0 Uploads

118 Posts

0 Threads

#3 15 years ago

Yer on the Dallas imo. Before u use the tricorder on the panel in Engineering, make sure u get the secret starship model first. Go into the warpcore room, go up, it should be there on the ramp. Once u succeed on that panel a forcefield with block the warpcore room.

As for the panel, first of all make sure u disconnect the red nodes. U then make two horizontal connections, pay attention u do not connect to a red node again. The top horizontal connection should be blue and the bottom yellow.

Took me awhile to figure it out.